Engineering Specification, 350 ton Solder Extrusion Press (O/No. 63680)
350 ton Solder Extrusion Press (O/No. 63680)
This page contains a précis of the Engineering Specification for the press stated above (as originally supplied).
Click here to see photographs of this press.
Click here, here and here to see photographs of similar presses.
If you have any comments, please leave your memories at the bottom of the page by clicking on the words Add a comment about this page.
Specification: | 350 ton horizontal, three-column, solder extrusion press | |
Main Characteristics: | Power of main ram | 350 tonf |
Power of drawback | 36 tonf | |
Stroke | 1′ 4″ | |
Container bore | 4″ dia. | |
Container length | 14″ | |
Size of billet | 3 7/8″ dia. x 12″ long | |
Billet Loader: | Supplied | |
Container Heating: | 12 x 500 watt sheathed cartridge heaters | |
Pump: | ‘Fielding’ A1, variable delivery pump, 4.5 gal/m @ 4500 psi | |
Motor: | 17 HP | |
Speeds: | Advance on prefill | 360 in/m |
Pressing | 0-6.5 in/m | |
Return | 0-69 in/m | |
Also included: | Dies, flux pot having an inner stainless steel container of approx. 800 cu. in capacity. | |
Multi-strand coiler suitable for coiling 8 strands of solder wire into pans situated below the coiler. 8 spare pans to be provided. Equipment driven by 1/4 HP variable speed geared motor suitable for coiling wire over the full speed range of the press | ||
Billet casting table capable of casting 4 – 2 5/8″ dia. billets up to 12″ long into moulds immersed in cold water | ||
Air compressor and receiver, 1 5/8″ bore x 2″ stroke, single cylinder compressor mounted onto a 2.7 cu. ft. capacity air receiver, driven by 3/4 HP, 1430 rpm, drip proof motor | ||
This specification was kindly provided by Rhodes Interform
No Comments
Add a comment about this page